
A Top Safety and Protection Solution Worldwide!
Page 16 of 32 Ver 1.0
Notice:
1) The SMS Alert number is for receiving the alarm SMS Message. The
Auto-Dial Telephone number is for receiving the calling. Try adding the
country code or removing country code when you can not receive the call or
SMS due to different GSM Operators with different communication protocols.
Our system will work with the international communications protocols.
2) The Auto-dial Tel. Number can dial to the device, 6 tones later, it can wiretap
the system site. Before 6 tones, if somebody answers the call, the two-way
voice communication will be activated. The other telephone numbers can call
the device, if nobody answers the call, they can not wiretap the system site, if
somebody answers the call, the two-way voice communication will activate.
1.SMS Phone No.
2. Auto-dial Tel No.
3. Time & Date
4. Sound Alarm
5. Report Time Gap
6. Power Failure Alert
7. Arm Delay Time
8. Alarm delay Time
---To setup the SMS Alert Number, must be cell
phone numbers, total 3.
---To setup the Auto-dial telephone number, total
is 5 numbers.
---To setup the time and date information. The
Format is Month-Date-Year. Press Up/Down to
setup each item, press * to move to next item.
---Switch on or off the siren when Alarm occurs.
---Setup the Report time gap, Range: 0~240
Hours. Default is 0, and will not report.
---Enable or Disable the alert function while the AC
power has failed for more than 30 minutes.
---Setup the delay time after arming the system
with remote control or keyboard. Optional: 0S,
20S, 30S, 60S, 90S. Default is 30S.
---Setup the delay time after any sensor triggered.
Optional: 0S, 20S, 30S, 60S, 90S. Default is
20S.
Komentáře k této Příručce