Alarmmate GSM Alarm System Uživatelský manuál stáhnout pdf (Strana 6)

A Top Safety and Protection Solution Worldwide!

Page ５ of 32 Ver 1.0

GND

Ground point, connect to another wire of the wired Detector.

IN4

Digital input 4, connect to one wire of the wired Detector.

IN5

Digital input 5, connect to one wire of the wired Detector.

GND

Ground point, connect to another wire of the wired Detector.

IN6

Digital input 6, connect to one wire of the wired Detector.

IN7

Digital input7, connect to another wire of the wired Detector.

GND

Ground point, connect to another wire of the wired Detector or

-12VDC.

IN8

Digital input 8, connect to one wire of the wired Detector.

+12V

+12VDC@1A power output for wired detectors.

R1+

Link-Output Relay, when the system alarm will close 4minutes.

(Rated Voltage: 3A/240VAC), this relay can connect to any other

lights or CCTV system as a switch.

R1-

Built in 240VAC@3A rated relay output, connect to the device’s

negative electrode.

R2+

Independent Output Relay, Can switch on or off by SMS

Commands. (Rated Voltage: 3A/240VAC), this relay is very

useful to switch on the lights when you can not come back in the

evening. Then after some hours you can switch off it.

R2-

Built in 240VAC@3A rated relay output, connect to the device’s

negative electrode.

4.2 Working Principle Drawing

The unit works with wireless detectors or wired detectors. It can switch on or

off one appliance by SMS command. Please see below:

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Žádné komentáře

Alarmmate GSM Alarm System Uživatelský manuál Strana 6